Shopping Cart

0 item $0.00

My Cart -

0 item

GSM 900Mhz Cellular Mobile Cell Phone Signal Amplifier Receivers Repeater Booster 300Sqm

$76.65

Availability: In stock

Quick overview

GSM 900MHz 68dB In Building Wireless Amplifier . This in-building amplifier is 68dB and suitable for home/small building use. It improves cell phone voice and data reception, adding bars of signal to your phone and increased data transfer speeds. It also helps prevent dropped calls. It doesn't require a direct connection to your phone, but rather works wirelessly. It can also work for multiple users at the same time. As part of the kit, antennas and cables included.
Qty:

GSM 900MHz 68dB In Building Wireless Amplifier
This in-building amplifier is 68dB and suitable for home/small building use. It improves cell phone voice and data reception, adding bars of signal to your phone and increased data transfer speeds. It also helps prevent dropped calls. It doesn't require a direct connection to your phone, but rather works wirelessly. It can also work for multiple users at the same time. As part of the kit, antennas and cables included.

This signal amplifier is 900MHz single band, meaning that it only works with the 900MHz network. It is mainly suit for the following area: Europe, Asia, Southeast Asia, Africa, the Middle East and Australia.

Features:

Small Size, Light Weight, Beautiful Repeater
Low Operating Temperature.
Full-Duplex Communication Mode
Antennas and Cables and AC power supply included.
CE Certification accepted.

Specification:

Model

PTE-G70

Specification

Uplink

Downlink

Frequency Range

890-915MHz

935-960MHz

Max. Gain (dB)

65dB±2dB

68dB±2dB

I/O Port

SMA Female on both ends

Impedance

50ohm

Power Supply

AC100-240V 50/60Hz 1A; DC 5V/1.5A

Weight

0.2Kg

Package Includes:

1 x 68dB 900MHz Repeater
1 x 8dBi Gain Outdoor Yagi with 10 meters cable
1 x 3/5dBi Gain Indoor Celling Antenna with 5 meters cable
1 x AC Adapter
4 x Screws for Mounting
1 x English User Manual

WHY REPEATER

1. Reason

(1) Blind or weak signal areas are formed if the buildings are too for away from CELL TOWER, or the buildings themselves shield or absorb signals.

(2) There are too many complicated signals in the higher part of the building, therefore ping-pong switching effect has been formed and the signals fluctuate a lot, there are annoying noises during phone calls and call drops according.

(3) Elevators and basements are well-known for blind areas.

(4) Downtown areas of the cities, which congested with many high-rise buildings, are usually the weak or blind areas.

(5) The remote villages, mountain, hills, valleys, etc, are mostly populated areas with quite few mobile users, so the main target is to send coverage to there areas, and it will not be worthy installing a CWLL TOWER, therefore a booster is a quite good option.

2. Solution

Our consumer repeater is the perfect solution for providing a wireless improvement in the cellular reception of a home, office, restaurant, VIP room, apartment, building or shopping mall, in the quickest time possibly. One repeater covers 300 to 2000 square meters.

Below diagram shows how simple and fast for the repeater system is installed and works effectively.

One Yagi antenna, as Outdoor antenna, is installed at the top of the roof to pick up good mobile signal from outside, and send though coaxial cable to repeater to amplify the signals significantly, them the output signals are divided into two signals by one 2way splitter, sent to two indoor Omni antennas and finally transmitted into area. Very clear phone call or high speed mobile data are immediately achieved withed within the area.


3. THE REPEATER SYSTEM


4. Installation

The signal repeaters should be used to cover the Indoor area. Humidity and temperature of working environment can affect the reliability of repeater. So, temperature, humidity, dust, interference, power, space requirements and other factors should be considered during installation of repeater.

4.1. Installation Location Requirement

(1). It is appreciated that repeater is installed in a cool, dry and ventilated room without erosive gas and smoke and without leakage on its proof.

(2).Or a cool and ventilated wall of which sun-proof and waterproof is expected.

(3).Besides above, common wall, tower or high pole is ok too.

(4).Installation height should be easy for RE cable wiring, heat dissipation, security and maintenance.

(5).Have a set of independent and stable power supply.

(6).Have lighting conductor in the building, tower or high pole with enough strength or stability.

4.2. Installation of Outdoor antenna

It is very important to choose the Outdoor antenna location in order to get the best signals.

Testing the signal strength received from Outdoor antenna mounted in site by mobile phone:

Please select the top of install the Outdoor antenna if total floors are less than 7 floors, and shall try your best to select places like balcony or platform lower than 7th floor for Outdoor antenna if the building are over 7 floors, because the mobile signals are clean at less than 7th floor.

The mobile phone shall display full bar signals in location where the Outdoor antenna is installed

The phone calls or data transmission shall be smooth and by 3 times testing in location where the Outdoor antenna is to be installed

As shown from the above illustration, testing the signals from A to E, and select a best place that displays full bar signals to install the Outdoor antenna.



Selecting the installation direction of Outdoor antenna.

The Outdoor antenna shall point to the directions of the tower, and it would be much better to keep line sight.

In order to avoid interference, please note that Outdoor antenna should be far away from the following objects of metal, high-voltage line, and RF antenna and high-voltage transformer.

5. Indoor antenna installation

 Proper antennas shall be according to the site conditions and the requirement. And more than one antenna can be used with the repeater.

(1). Indoor ceiling Omni antenna is suitable to be installed in the center and radiate all directions.


(2). It is better to use a directional panel antenna when the coverage shape is long and narrow (corridors, long row of houses in two sides, tunnels or elevators or rural open space).



(3). The small whip antenna to be installed use for small room or apartment. It is very convenient for simple use with a good result.

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Only registered users can write reviews. Please, log in or register

Color No